Written scope
What we found and what we will fix
Plumbing repairs in Houston are the everyday calls: a dripping faucet, a running toilet, a leaking supply line, a slow drain. Most plumbing calls are repairs, not replacements: a dripping faucet, a running toilet, a leaking supply line, a slow drain. El Primo Lalo Plumbing diagnoses the cause first, then repairs it and tests before leaving, with a free estimate and a written scope you approve.
Every Plumbing Repairs in Houston job includes the basics: a diagnosis, an written estimate, the repair itself, and a test to confirm it holds. What changes is the scope. A faucet cartridge is a different job than a slab leak. Here is what is covered on a standard call.


Your house has its own plumbing map, and we learn it before we cut anything. From a dripping faucet to a slab leak, we fix the problem and show you what we did.
A plumbing problem during business hours costs you customers. We schedule around your operating hours and keep the water on where we can.
A good repair starts with the right diagnosis. A running toilet is usually a flapper, fill valve or chain. A rocking toilet base points to a wax ring or flange. A dripping faucet is usually a cartridge or seat. A leak under a sink can be a supply line, a trap or a shutoff valve that has given up. Guessing wastes a visit; finding the failed part fixes it once.
Houston's water and soil shape the repair list. City water averages about 8 grains per gallon, so scale builds in cartridges, fill valves and heater elements. Expansive clay moves slabs and flexes buried lines. And the housing stock is old enough that galvanised, cast iron and copper all show up in the same week. We carry common fittings on the truck so most repairs finish in one visit.
Find the failed part. A repair that guesses is a repair you pay for twice.
From the first call to the final test, here is exactly what happens when you book Plumbing Repairs in Houston with us.

Listens for the sound of water escaping under a slab or behind a wall. It lets us pinpoint the leak without tearing up the whole floor.

A camera on a reel goes down the main line and shows us the break, the roots, or the bellied pipe. We record the footage so you see what we see.

Blasts grease and roots off the pipe walls with high-pressure water. It cleans better than a snake and leaves the line ready for camera inspection.

Crimps push-fit and expansion fittings onto PEX and copper without a torch. Faster and safer in tight spaces where a flame is a bad idea.

The basics. A pipe wrench breaks loose old fittings, and an auger clears a clogged branch line without a full machine.

For copper joints that need a soldered connection. We use it where code requires a soldered joint or where a press fitting will not fit.

Every repair meets the UPC and the local Houston amendments. That means the right pipe material, the right slope on drain lines, and the right venting. It matters when you sell the house or pull a permit.

We cap the line, pressurize it, and watch the gauge. A joint that holds pressure holds water. We do not call a repair done until the gauge stays put.
That is a hidden leak until proven otherwise. We come out, run leak detection, and find it before it rots a subfloor. You get the leak fixed and a water bill back to normal.
Shut off the main, then call us. We respond for emergency plumbing repairs Houston calls and stop the damage before it spreads. The pipe gets repaired and the water is back on once the repair is done, in most cases.
That unit is on borrowed time. We quote a replacement and install a new tank sized for your home. Hot water back on, and no more rust in the tub.
We replace the flapper and fill valve. It is a quick fix that pays for itself on the next water bill. The toilet stops running and your bill drops.
The Heights and Montrose bring pre-1960s galvanised and cast-iron repairs, Garden Oaks and Oak Forest bring mid-century fixtures, and Sharpstown and Meyerland bring slab-era copper and cast-iron drain work.
The homeowner heard water running at night and saw the water bill jump sharply. A moisture meter showed a hot spot under the living room floor. The copper line under the slab had pinhole leaks from years of contact with the concrete.
We rerouted the line overhead through the attic instead of breaking up the slab. The repair took one day, the water bill went back to normal, and the floor stayed intact.
Keep an eye on the water bill and check the attic run once a year for condensation or drips. A pressure regulator set at 60 psi protects the new line.
The sewer backed up into the laundry room twice in six weeks. A camera showed roots in the cast iron line and a section that had bellied and cracked. Snaking only cleared it for a few weeks.
We dug up the bad run and replaced 30 feet with new PVC pipe. The camera showed a clean line with no roots. No backups in the months since.
Have the line camera-checked every two years. Avoid pouring grease down the drain, and keep trees at least 10 feet from the sewer run.
The homeowner had low pressure at every fixture and rusty water in the morning. The house still had the original 1950s galvanized supply lines, choked with scale and leaking at three joints.
We repiped the house with PEX in two days. Pressure at the shower went from a trickle to full flow, and the rust in the morning water stopped.
Run a water softener to slow scale buildup in the new pipe. Check the shutoff valves once a year and exercise them so they do not seize.
These are the calls we get most often. If yours is not on the list, call anyway. We have seen it.

We use a leak detection microphone and moisture meters to pinpoint the leak without breaking up the whole floor. Then we either tunnel under the slab or reroute the line overhead, depending on what saves you money. A slab leak can waste thousands of gallons and crack your foundation. The longer it runs, the more the repair costs.

We camera the line to find the intrusion, cut the roots with a drain snake or hydro jetting machine, and repair the cracked section. If the damage is bad, we replace that run with new PVC. Roots find the smallest crack and grow into the pipe. Once inside, they catch grease and paper and cause repeated backups.

We replace the flapper, fill valve, or both. Most toilet repairs take under an hour and cost far less than the water bill you are paying now. A running toilet can waste 200 gallons a day and add a large amount to your water bill each month.

We test pressure at the main and at fixtures to isolate the cause. If the regulator is bad, we replace it. If the galvanized pipe is choked with scale, we quote a repipe. Low pressure makes showers miserable and can signal a failing pressure regulator or a corroded galvanized line.
Call (346) 776-8560 during our hours — Monday through Sunday, 7:00 AM to 10:00 PM — and we will talk through the next step. A running toilet can waste 200 gallons a day, and a pinhole leak can rot a cabinet in a week. We treat both like the emergencies they are.
You get the price before we pick up a pipe wrench. No hourly meter running while we work, no surprise line items. For plumbing repairs Houston Texas residents can budget for, we quote the job, you approve it, and that number stands.
Every repair meets the 2021 Uniform Plumbing Code with Houston Amendments and local Houston amendments. That matters when you sell a house or when an inspector looks at a remodel. We use push-fit and expansion fittings rated for the pressure and pull the right permits when the job requires one.
We lay drop cloths, cut clean, and haul off old pipe and debris. Before we leave, we run water, check for weeping joints, and confirm the fix holds under pressure. You get a dry floor and a repair that lasts.
Clear records you can keep and share.
What we found and what we will fix
The number before any work starts
Pressure test and fixture check before we leave
The cheapest quote is not always the cheapest repair. Ask what the diagnosis found and whether the fix addresses the cause or just the symptom.
A camera or leak detector tells you what failed. A quote without a diagnosis is a guess. Ask to see the footage or the moisture reading.
A single pinhole leak in copper can be cut out and repaired. A line that is failing joint by joint is better replaced. Ask which one you are getting.
Repipes and water heater swaps need a city permit. Ask who pulls it. A repair without a permit can cause a problem when you sell the house.

Outside these areas? Call and ask if we can reach you. (346) 776-8560
Dripping faucets, running toilets, leaking supply lines and shutoff valves, slow drains, and water heater problems. Hard water scale is behind a surprising share of them: it wears cartridges, fill valves and heater elements.
We do not publish prices, because the cost depends on the failed part, access and material. Every job starts with a free estimate and a written scope you approve before we start, so there are no surprises.
Repair when the fixture is sound and only a part has failed, such as a cartridge, flapper or supply line. Replace when the body is cracked, corroded through, or parts are no longer available. We show you the failed part so you can decide.
Yes. Estimates are free, and you approve the written scope before work starts. We are open Monday to Sunday, 7:00 AM to 10:00 PM.
Call (346) 776-8560 and describe the problem. We will give you a free estimate, find the failed part, and repair and test it, Monday to Sunday, 7:00 AM to 10:00 PM.
Call us at (346) 776-8560 to book a plumbing repair or ask a question. We are open Monday to Sunday, 7:00 AM to 10:00 PM, and estimates are free.
The fastest way to book is a phone call. Tell us what is happening and we will give you a free estimate and a time that works, Monday to Sunday, 7:00 AM to 10:00 PM.
Open Mon–Sun, 7:00 AM–10:00 PM. Free estimates.