Written scope
Clear price and work description before we start
Pipe repair in Houston is the work of matching the repair to the pipe: a pinhole in copper, a cracked cast-iron section, a pipe split by a freeze. A pinhole leak in copper, a cracked cast-iron section, a pipe split by a freeze: each needs a different repair, and each needs testing after. El Primo Lalo Plumbing repairs water and drain pipe in Houston to the 2021 Uniform Plumbing Code with Houston Amendments, with a free estimate first.
Every pipe repair starts with a real diagnosis and ends with a pressure test. Here is what is covered in a standard repair, and what we quote separately when the job calls for it.


Homes in Houston deal with slab leaks, frozen splits, and corroded lines that drop pressure over time. We find the failure, repair the line, and test it before we leave.
Restaurants, offices, and retail properties need repairs that keep the doors open and pass inspection. We schedule around your hours and document the work.
Houston homes carry four pipe generations, and each fails differently. Galvanised steel from before the 1970s rusts from the inside out. Copper develops pinhole leaks, and Houston's water chemistry and slab foundations make them surprisingly common. Cast iron scales and cracks. Polybutylene from the late 1970s to the mid-1990s is notorious for sudden failures. The material decides the repair.
Freeze damage is the sharpest seasonal cause. The split forms during the freeze and the leak appears on the thaw, with attic runs freezing first and leaking onto ceilings. A repair after a freeze has to be checked along the whole run, not just at the visible split, because a line can split in more than one place.
Match the repair to the pipe. Copper, cast iron, galvanised and PEX all fail differently.
From the first call to the final pressure test, here is what you experience when you book pipe repair services Houston TX with us.

Listens for the sound of escaping water under slabs and behind walls so we open one spot instead of a whole room.

Inspects drain and sewer lines for cracks, root intrusion, and offsets before and after repair.

Makes fast, reliable press connections on copper and PEX without open flame in tight spaces.

Cuts copper and plastic pipe square for clean joints and proper fit.

Solders copper joints where code and access allow a traditional connection.

Provides code-approved push and crimp connections for repairs and transitions.

We isolate the repaired section and pressure-test it before restoring water. A joint that does not hold gets redone before we leave.

Copper gets soldered or pressed, PEX gets crimped or expanded, PVC gets solvent-welded, and cast iron gets the correct coupling. No mismatched patches.
We locate the hidden leak with a microphone and camera, confirm the source, and repair the line before it damages the structure. The leak stops, the bill normalizes, and you avoid a bigger tear-out later.
We triage on the phone, help you shut off the main, and send a tech for emergency pipe repair Houston near me calls during our hours — Monday through Sunday, 7:00 AM to 10:00 PM. Water damage is limited, the line is repaired, and the area is tested before we leave.
We inspect the exposed pipe, replace failing sections with matched material, and update shutoff valves while the wall is open. The remodel closes up on sound plumbing instead of a future leak.
We repair the split, check nearby lines for damage, and pressure-test the system. Water is back on, and you know which lines to insulate before the next freeze.
Pier-and-beam homes in the Heights, Montrose and the Third and Fifth Wards carry galvanised and cast-iron pipe, while slab homes in Sharpstown and Meyerland carry copper under concrete. Freeze damage hits attic runs across the whole city.
A homeowner noticed a warm spot on the floor and a water bill that jumped sharply in one month. Two other companies quoted a full room tear-out without locating the leak.
We located the failure within 18 inches using a microphone and camera, opened one small section, repaired the copper line, and pressure-tested it. The patch was minimal and the bill returned to normal.
We advised monitoring the water bill monthly and checking for new hot spots after seasonal soil shifts.
A hard freeze split an exposed line in a pier-and-beam crawlspace. Water was running under the house and the homeowner could not find the shutoff.
We walked the homeowner through the shutoff by phone, arrived during our hours, repaired the split section, and checked the rest of the crawlspace lines. Pressure test passed and water was back on by evening.
We recommended insulating the exposed runs and sealing the crawlspace vents before the next freeze.
A 1950s home had rusty water and low pressure at the kitchen faucet. A previous patch on the galvanized line was already leaking again.
We replaced the failing section with copper and added new shutoff valves. Pressure at the kitchen faucet came back to normal and the rusty water cleared within a day.
We mapped the remaining galvanized runs and gave the homeowner a phased plan for replacement.
Most pipe failures in Houston fall into a few patterns. Here is what we see and how we handle it, including the burst pipe repair Houston TX calls that cannot wait.

We cut out the pitted section, repair with new copper or a proper transition fitting, and check the rest of the run for similar damage. Small leaks soak drywall and cabinets and can turn into a full split under pressure. They rarely fix themselves.

We locate with a leak detection microphone and camera, open one targeted spot, repair the line, and pressure-test before patching. Water under a slab can shift soil, crack flooring, and run up the water bill fast. Guessing at the location gets expensive.

We shut off the water, repair the split section, and check exposed lines for other weak points. We also advise on insulation for next season. A split line releases water fast and can flood a room in minutes. Houston homes are not always built for hard freezes.

We assess the run and recommend spot repair or replacement. When the line is too far gone, we quote pipe replacement or repiping with copper or PEX. Old lines rust from the inside, drop pressure, and eventually fail. Patches on failing pipe do not last.
Burst lines and slab leaks do not wait for business hours. We prioritize emergency pipe repair Houston calls. Call (346) 776-8560 during our hours — Monday through Sunday, 7:00 AM to 10:00 PM — and we will talk through the next step.. We shut off the water, isolate the failure, and stop the damage before it spreads.
Every repair meets 2021 Uniform Plumbing Code with Houston Amendments standards, and we pull permits when the job requires it. That matters at resale and when an inspector looks at a remodel. We use push-fit, expansion, and press fittings where they fit the application.
Copper, PEX tubing, PVC, CPVC, or cast iron, we match the material to the line and the water. Copper pipe repair Houston homes need may call for soldered joints, while a PEX run in a crawlspace gets crimped fittings. No mismatched patches that fail next season.
You get a clear price before we start. pipe repair Houston Texas does not mean cheap parts or skipped steps, it means honest scope and honest numbers. We tell you what the repair costs, what caused it, and whether a patch or a replacement makes more sense.
Clear records you can keep and share.
Clear price and work description before we start
Proof the repaired line holds before we leave
What pipe and fittings went into the repair
The biggest cost difference in pipe repair is access, not parts. A repair that is located first stays small; a repair that is guessed at gets expensive.
A leak detection microphone and camera find the failure before a wall or slab is opened. That keeps the repair targeted and the patch small.
Copper, PEX, PVC, and cast iron each need the right joint and fitting. A mismatched patch can fail within a season, especially under pressure.
A pressure test confirms the joint holds before drywall or concrete goes back. Skipping that step is how a small leak becomes a second repair.

Outside these areas? Call and ask if we can reach you. (346) 776-8560
We do not publish prices, because the cost depends on the pipe material, the location and the access. A single exposed repair is one job; a repair under a slab is another. Every job starts with a free estimate and a written scope you approve before we start.
A single split can usually be repaired. A line that has split in several places, or a systemically tired pipe with recurring pinholes, is a replacement or repipe conversation. We check the whole run, not just the visible split.
Water chemistry, age and the way copper rubs against concrete under a slab all play a part. In Houston, copper pinhole leaks are surprisingly common, and recurring pinholes across a house usually point to a repipe, not another spot repair.
Yes. Estimates are free, and you approve the written scope before work starts. We are open Monday to Sunday, 7:00 AM to 10:00 PM.
Call (346) 776-8560 for a free estimate. We find the failed section, repair it to code, and test before we leave, Monday to Sunday, 7:00 AM to 10:00 PM.
Call us at (346) 776-8560 to book pipe repair or ask a question. We are open Monday to Sunday, 7:00 AM to 10:00 PM, and estimates are free.
The fastest way to book is a phone call. Tell us what is happening and we will give you a free estimate and a time that works, Monday to Sunday, 7:00 AM to 10:00 PM.
Open Mon–Sun, 7:00 AM–10:00 PM. Free estimates.